Checking if your kit is complete... Looks good Writing Makefile for Math::FitRect cp FitRect.pm blib/lib/Math/FitRect.pm Manifying blib/man3/Math::FitRect.3 PERL_DL_NONLAZY=1 /home/cpanrun/pa-risc1.1/build/5.8.2/bin/perl "-Iblib/lib" "-Iblib/arch" test.pl 1..12 ok 1 - Module loaded fine. ok 2 - Normalize a scalar square. ok 3 - Normalize a array ref rectangle. ok 4 - Normalize a hash ref rectangle. ok 5 - Fit a larger square in to a smaller square. ok 6 - Fit a smaller square in to a larger square. ok 7 - Fit a larger rectangle in to a smaller rectangle. ok 8 - Fit a smaller rectangle in to a larger rectangle. ok 9 - Fit a larger square in to a smaller square. ok 10 - Fit a smaller square in to a larger square. ok 11 - Fit a larger rectangle in to a smaller rectangle. ok 12 - Fit a smaller rectangle in to a larger rectangle. Installing /home/cpanrun/pa-risc1.1/build/5.8.2/lib/site_perl/5.8.2/Math/FitRect.pm Installing /home/cpanrun/pa-risc1.1/build/5.8.2/man/man3/Math::FitRect.3 Appending installation info to /home/cpanrun/pa-risc1.1/build/5.8.2/lib/5.8.2/PA-RISC1.1-thread-multi/perllocal.pod