Checking if your kit is complete... Looks good Writing Makefile for Log::Log4perl::ConfigByInifile cp lib/Log/Log4perl/ConfigByInifile.pm blib/lib/Log/Log4perl/ConfigByInifile.pm Manifying blib/man3/Log::Log4perl::ConfigByInifile.3 PERL_DL_NONLAZY=1 /home/cpanrun/parisc2.0-lp64/build/5.8.2/bin/perl "-MExtUtils::Command::MM" "-e" "test_harness(1, 'blib/lib', 'blib/arch')" t/*.t t/001_load....1..1 ok 1 - use Log::Log4perl::ConfigByInifile; ok t/002_new.....ok 1 - Module can new ok 2 - new dies without arguments ok 3 - Bad Inifile '/home/cpanrun/depot/main/contrib-patched/perl/CPAN/src/Log-Log4perl-ConfigByInifile/t/bad.ini' found ok 4 - Good Inifile '/home/cpanrun/depot/main/contrib-patched/perl/CPAN/src/Log-Log4perl-ConfigByInifile/t/good.ini' found ok 5 - new dies with 2 good arguments which is too much ok 6 - new dies if arg ini_file is not a file ok 7 - new dies if arg ini_obj is not of type Config::IniFiles ok 8 - new dies if arg ini_file without section log4perl ok 9 - new survives with arg ini_file with section log4perl ok 10 - Loglevel of main is INFO ok 11 - Loglevel of somewhere is INFO ok 12 - Loglevel of juhei is DEBUG 1..12 ok All tests successful. Files=2, Tests=13, 1 wallclock secs ( 1.33 cusr + 0.19 csys = 1.52 CPU) Installing /home/cpanrun/parisc2.0-lp64/build/5.8.2/lib/site_perl/5.8.2/Log/Log4perl/ConfigByInifile.pm Installing /home/cpanrun/parisc2.0-lp64/build/5.8.2/man/man3/Log::Log4perl::ConfigByInifile.3 Appending installation info to /home/cpanrun/parisc2.0-lp64/build/5.8.2/lib/5.8.2/PA-RISC2.0-thread-multi-LP64/perllocal.pod