Checking if your kit is complete...
Looks good
Writing Makefile for Simulation::Automate
cp Automate/PreProcessors.pm blib/lib/Simulation/Automate/PreProcessors.pm
cp Automate.pm blib/lib/Simulation/Automate.pm
cp Automate/Remote.pm blib/lib/Simulation/Automate/Remote.pm
cp Automate/PostProcLib.pm blib/lib/Simulation/Automate/PostProcLib.pm
cp Automate/Analysis.pm blib/lib/Simulation/Automate/Analysis.pm
cp local_install.pl blib/lib/Simulation/local_install.pl
cp Automate/PostProcessors.pm blib/lib/Simulation/Automate/PostProcessors.pm
cp Automate/Dictionary.pm blib/lib/Simulation/Automate/Dictionary.pm
Manifying blib/man3/Simulation::Automate.3
PERL_DL_NONLAZY=1 /home/cpanrun/tmp/5.8.0/bin/perl "-Iblib/lib" "-Iblib/arch" test.pl
1..1

SynSim Installation Test

Simulation::Automate version 1.0.1

Installed locally in /home/cpanrun/depot/main/contrib-patched/perl/CPAN/src/Simulation-Automate/eg

Finished SynSim run

ok 1
Warning: You do not have permissions to install into /usr/local/bin at /home/cpanrun/build/5.8.0/lib/5.8.0/ExtUtils/Install.pm line 84.
Installing /usr/local/bin/synsim
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/local_install.pl
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/PreProcessors.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/Remote.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/PostProcLib.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/Analysis.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/PostProcessors.pm
Installing /home/cpanrun/build/5.8.0/lib/site_perl/5.8.0/Simulation/Automate/Dictionary.pm
Installing /home/cpanrun/build/5.8.0/man/man3/Simulation::Automate.3
Appending installation info to /home/cpanrun/build/5.8.0/lib/5.8.0/i686-linux-thread-multi/perllocal.pod